How do I set up my Wassermaxx Triton drinks maker?

  1. Remove the parts from the packaging: 1 device head with pre-inserted bottle; 1 column including the drinks maker; base and drip tray; 1 CO2 cylinder
  2. Use only the original accessories that are included or those recommended by the manufacturer. Under any other circumstances, the guarantee and warranty will be void.
  3. The drinks maker is supplied with a pre-inserted bottle. Lay the device head upside-down on a level surface. Turn the bottle counter-clockwise and remove it by pulling up.
  4. Remove the tamper evident sleeve from the CO2 cylinder head and pull off the safety cap.
  5. Remove the inserted plastic shipping guard from inside the drinks maker head. Insert the CO2 cylinder and screw it tightly into the cylinder holder (do not use any tools)
  6. Place the column including drinks maker base and drip tray in an upright position.
  7. Insert the cylinder into the cylinder tube of the column. Looking from the back, the drinks maker head should be turned slightly to your left, so that the “I” marking on the device head is directly in line with (above) the right “I” marking on the lower section of the device.
  8. Turn the drinks maker head to the right until you feel a click, so that it is properly locked.
  9. Make sure that the drinks maker head is closed. In the closed position, the “I” marking will be in line with the left “I” marking on the lower section of the back part of the drinks maker base including the drip tray.

 

Congratulations – you are now ready to begin using your Wassermaxx Triton drinks maker!